SDW 30/60 HS - Replacing the battery

Required material:

  • new Battery pack for SDW 30 HS/SDW 60 HS - ID No. AHB732038TPCT
  • Tool such as a small plastic rod and paper clip for SDW 60 HS

Disassembling the rechargeable battery pack:

Opening the battery compartment

1. SDW 30 HS: Slide one finger into the small recess on the side support.

SDW 60 HS: Use a paper clip or similar tool to press the unlock button and turn the cover a bit.

The battery compartment lifts a bit.

2. Gently remove the battery compartment cover.

Removing the rechargeable battery:

1. Use a plastic tool (e.g small plastic lifting rod) to lift the rechargeable battery. Please note, that the battery is attached with an adhesive.

2. Remove the rechargeable battery.

3. Carefully loosen the connector plug.

Assembling the new battery pack:

1. Rotate the battery so that the marking signs are visible at the top. Insert the connector plug of the new rechargeable battery into the connection socket. Observe correct orientation of the connector plug.

2. Press on the plastic parts to securely lock the connector plug.

3. Insert the battery and assure that the marking signs are visible at the top. Place the battery centered to secure an air gap around it.

4. Make sure that the wires are aligned and not crossing over each other. Gently press down the three wires and the battery.

5. Slide the battery compartment cover.

6. SDW 30 HS: Start attaching the lower side (as shown below) and then push the other side down. Finally, push the sides into place.

SDW 60 HS: Close the battery compartment and turn the lid clockwise. You hear a click.

Testing the battery and final adjustments:

1. Test the function of the headset: Press the hook button to switch on the headset. The LED lights up blue.

2. Charge the battery for at least 20 minutes before using the headset. See User guide for further information.

3. Switch off the headset before sending it to the customer. Press and hold the Hook button for 5 seconds. The headset switches off. The headset LED flashed red 3 times and turns off.